Krohne IFC 010 Converter Short EN Manuel d'utilisateur

GRCondensed InstructionsIFC 010 CIFC 010 WSignal converters for OPTIFLUX flowmetersVariable area flowmetersVortex flowmetersFlow controllersElectromag

10 IFC 010 3 Start-up 3.1 Powering up and measurement The flowmeter is delivered ready for use. All operating data have been factory set in ac

IFC 010 11 Standard factory settings Function Setting 1.01 Full-scale range Q100% see nameplate 1.02 Time constant 3 s, for I, S a

12 IFC 010 Part B IFC 010 _ / D Signal converter 4 Operation of the signal converter 4.1 Operating concept 1

IFC 010 13 4.2 Table of settable functions Function Text Description and settings 1.00 OPERATION Operations menu 1.01 FULL SCALE F

14 IFC 010 Function Text Description and settings 1.05 CURRENT I Current output I → FUNCT. I Select function for current output I

IFC 010 15 Function Text Description and settings 3.00 INSTALL. Installation menu 3.01 LANGUAGE Select language for display texts

16 IFC 010 4.3 Error messages in measuring mode The following list gives all errors that can occur during process flow measurement. Errors shown

IFC 010 17 Notes

18 IFC 010 Notes

IFC 010 19 Return a device for testing or repair to KROHNE This device has been carefully manufactured and tested. If installed and operated in

2 IFC 010 Contents 1 Electrical connection: power supply...

IFC 010 3 1 Electrical connection: power supply 1.1 Important installation notes 1.1.1 Location Electrical connection in accordance

4 IFC 010 1.2 Connection to power Rated values: The flowmeter housings protecting the electronic equipment from dust and moisture must alwa

IFC 010 5 1.3 Electrical connection of separate flow sensor (W Versions) 1.3.1 General information on signal cable A and field current cable

6 IFC 010 Preparation for connection to IFC 010 W signal converter Length Ferrule mm inch a 90 3.60 b 8 0.30 c 25 1.00

IFC 010 7 1.3.5 Connection diagrams I and II (power supply, converter and flow sensor) The figures in brackets indicate the stranded drain w

8 IFC 010 Connection of shields to the IFC 010 1 DS Signal cable 2 Shield terminal for shielded signal cable 3 Field power cable

IFC 010 9 2.3 Connection diagrams for outputs DC voltage, external power source (Uext), note connection polarity External voltage source (